Please note that these will ship Friday May 18th.
Save Your Engine!
The 2005.5-2006 MK5 Jetta TDI BRM engine mount fix bracket provides a secure point to attach your engine mount bracket after the cast iron mounting ear breaks off (Click for another picture). Installation of this part requires that you first remove the EGR cooler (you reinstall the EGR cooler after the fix bracket has been installed). Kit comes with all hardware to attach the VanGogh bracket to the engine.
For our customers outside of North America:
This bracket also fixes later European-spec Pumpe Düse TDI engines, otherwise known as "PD" engines. To determine whether this bracket will fit your euro-spec TDI engine you must physically check whether your engine block has the diagonal gusset as shown in the picture below. This BRM VanGogh bracket fits TDI engines with the diagonal gusset shown below. If you have a PD engine and the diagonal gusset is not present on your engine block you will use the 20mm version of the $49.00 ALH & BEW VanGogh bracket.
About your broken aluminum accessory bracket...
Oftentimes, when the ear breaks off of your engine block, the aluminum accessory bracket that holds your AC compressor and alternator also breaks where the engine mount bracket attaches to it. To get around having to replace the aluminum accessory bracket there is an alternative VW engine mount bracket and hardware available from your local VW dealer that can be used. This will save you a lot of time. The part numbers for the bracket and hardware are as follows:
03G 199 207G Updated engine mount bracket 1x
N 106 833 01 Longest horizontal MM bolt M10x115 1x
N 106 558 02 Mid-length horizontal MM bolt M10x85 1x
N 106 802 01 Shortest horizontal MM bolt M10x75 1x
