24mm Tri socket rental for the center plug seal
Special three sided 24mm socket for TDI VE injection pump head plug seal
 
In Stock!
Our Price: $50.00
Qty:

Description
 
This is a $15 rental of our specially machined 24mm tri socket to replace the center plug seal on the TDI injection pump.

Added to the rental price is a $5.00 prepaid US domestic USPS Priority Mail return shipping label to return the socket after the seal has been replaced. Just drop it in the mail when you are done. (If you are outside of the US you can email us for instructions on how to rent the tool.)

A $30 deposit is part of the $50 price and is refundable within 20 calendar days of placing a rental order for this socket, assuming the tool is returned in usable condition.

Please select the shipping carrier and speed of outbound shipping you require during checkout.

Installation of center plug seal: Remove injector lines from engine. Remove center plug with the 24mm tri socket. Remove the o-ring seal from center plug, clean the plug and replace with new seal found in the Bosch seal kit listed below. (Do not loosen the 12mm-headed calibration screw in the center of the center plug.) Replace center plug and injector lines, re-prime pump and start the engine. Check for leaks. There are no special tricks or anything to fall out of place when doing this procedure. It's a simple replacement of an o-ring and nothing more. "Good and tight" (Gutenteit) is the official Bosch torque spec.

Accessories
Fuel Temperature Sensor for 1996-2003 TDI 028 906 040C Viton Pump Head O-Ring Seal Kit MN3001 Metalnerd Socket for Bosch Triangular Bolt Bosch Injection Pump Seal Kit for TDI
Sale Price: $19.00
Sale Price: $9.00
Our Price: $23.00
Sale Price: $19.00
TDI fuel temperature sensor with VW part number 028 906 040C Viton TDI pump head seal for Bosch VW TDI injection pumps Anti tamper socket for top of VW TDI injection pump TDI injection pump seal kit for ALH, 1Z, and AHU engines

Average Rating: 5 of 5 Total Reviews: 2 Write a review »

  0 of 0 people found the following review helpful:
 
Perfect Tool to fix a leak November 5, 2016
Reviewer: Tim from PA  
This review is more for Jim's service than the tool itself.

The tool works, shipping was way faster than could be expected, included a return envelope, and was exactly as described.

I had been chasing a fuel leak. Did the pump head seal using Jim's guides and videos. Leak had stopped. Then it came back. On a Sunday afternoon, Jim replied to an email about a leaking pump with suggestions of what else it might be.

He looked at my order history, and even told me I already had the seal, just needed the tool to fix this o-ring.

I can not recommend DieselGeek enough. They are what all businesses should be.

Was this review helpful to you?

  1 of 1 people found the following review helpful:
 
Socket for Fixing Leaky Injection Pump December 3, 2012
Reviewer: Tim Peters from San Antonio, TX  
This socket was exactly what I needed to fix my leaky injection pump. This enabled seamless removal of the seal on the end of the pump. No more leaky pump and great mileage has returned!

Was this review helpful to you?